Hallo,
hier einmal der Code:Einen Schaltplan gibt es leider nicht. Hier aber einfach die verbundenen Anschlüsse:
RasaPi-Pin: VL53L0X-Pin:
3.3V VIN
GND GND
SDA SDA
SCL SCL
GPIO 15 XSHUT Sensor 1
GPIO 17 XSHUT Sensor 2
Die XSHUT Pins habe neinen internen Pullup-Widerstand ( ich glaube 56k).
hier einmal der Code:
Code:
import timeimport boardimport RPi.GPIO as GPIOimport adafruit_vl53l0xi2c = board.I2C()GPIO.setup(15, GPIO.OUT)GPIO.setup(17, GPIO.OUT)GPIO.output(15, True)GPIO.output(17, True)print ("Performing reset")GPIO.output(15, False)GPIO.output(17, False)time.sleep(10)print("reset done")GPIO.output(17, True)try: vl53_2 = adafruit_vl53l0x.VL53L0X(i2c) vl53_2.measurement_timing_budget = 200 vl53_2.set_address(0x30) print("Sensor 2 fertig")except Exception as e: print(e) time.sleep(2)try: GPIO.output(15, True) vl53_1 = adafruit_vl53l0x.VL53L0X(i2c) vl53_1.measurement_timing_budget = 200 print("Sensor 1 fertig")except Exception as e: print(e)print("Fertig")RasaPi-Pin: VL53L0X-Pin:
3.3V VIN
GND GND
SDA SDA
SCL SCL
GPIO 15 XSHUT Sensor 1
GPIO 17 XSHUT Sensor 2
Die XSHUT Pins habe neinen internen Pullup-Widerstand ( ich glaube 56k).
Statistics: Posted by Danny09 — Thu Jan 18, 2024 10:45 am