Hi,
Did not see an IO board forum, so hoping this post is OK here.
I have an IO Board, with a battery installed (and confirmed supplying 3.1 VDC). I added `dtoverlay=i2c-rtc,pcf85063a,i2c_csi_dsi` to /boot/firmware/config.txt
i2cdetect -y 10 does not seem to find the RTC?Most google results starts after the device is shown with i2cdetect.
Any suggestions on what to try next?
TX!
Bas
Did not see an IO board forum, so hoping this post is OK here.
I have an IO Board, with a battery installed (and confirmed supplying 3.1 VDC). I added `dtoverlay=i2c-rtc,pcf85063a,i2c_csi_dsi` to /boot/firmware/config.txt
i2cdetect -y 10 does not seem to find the RTC?
Code:
0 1 2 3 4 5 6 7 8 9 a b c d e f00: -- -- -- -- -- -- -- --10: -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- --20: -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- --30: -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- --40: -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- --50: -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- --60: -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- --70: -- -- -- -- -- -- -- --Any suggestions on what to try next?
TX!
Bas
Statistics: Posted by basrijn — Tue Apr 09, 2024 2:31 am