Using the following
https://www.raspberrypi.com/documentati ... stallation
I double check the connection ribbon. As received in the box, the connection ribbon was incorrect.
Instructions state the following.
Disconnect the ribbon cable from the M.2 HAT+, and insert the other end into the PCIe port of your Raspberry Pi. Lift the ribbon cable holder from both sides, then insert the cable with the copper contact points facing inward, towards the USB ports.
And
Insert the ribbon cable into the slot on the M.2 HAT+. Lift the ribbon cable holder from both sides, then insert the cable with the copper contact points facing up. With the ribbon cable fully and evenly inserted into the port, push the cable holder down from both sides to secure the ribbon cable firmly in place.
I did both, reassembled the pi into the case and booted.
Unfortunately, still not seeing the SSD.
https://www.raspberrypi.com/documentati ... stallation
I double check the connection ribbon. As received in the box, the connection ribbon was incorrect.
Instructions state the following.
Disconnect the ribbon cable from the M.2 HAT+, and insert the other end into the PCIe port of your Raspberry Pi. Lift the ribbon cable holder from both sides, then insert the cable with the copper contact points facing inward, towards the USB ports.
And
Insert the ribbon cable into the slot on the M.2 HAT+. Lift the ribbon cable holder from both sides, then insert the cable with the copper contact points facing up. With the ribbon cable fully and evenly inserted into the port, push the cable holder down from both sides to secure the ribbon cable firmly in place.
I did both, reassembled the pi into the case and booted.
Unfortunately, still not seeing the SSD.
Statistics: Posted by ipmaercyrrebpsar — Sun Jan 12, 2025 2:02 am
