Raspberry Pi 400 and 500 • Will a Bookworm OS made on a 500 work on a 400?
I have a Pi 400 and want to order a 500. I want to be able to keep using the 400 while also setting up a new memory card with Bookworm. Can I do it on the 500 and then just move the card to the 400?...
View ArticleRaspberry Pi 400 and 500 • Re: Will a Bookworm OS made on a 500 work on a 400?
yesStatistics: Posted by kerry_s — Mon Jan 20, 2025 4:50 am
View ArticleCamera board • Re: Arducam IMX462 Ultra Low Light Camera Review
Here's a message in the bottle for anyone wanting good daylight/nighttime performance camera for their Raspberry PI or any other security project:https://amcrest.com/4k-poe-camera-turre ......
View ArticleCompute Module • Re: CM5: What's the status of audio on GPIO 12~13?
I am a uconsole owner who is awaiting a CM5 for my uconsole and I can read in here that Audio isnt yet working for the CM5? I would be very interested if this was working and I hope the community...
View ArticleRaspberry Pi OS • Re: Set cpu frequency
We set ondemand governor in /etc/init.d/raspi-config.That file don't exist in my Raspberry Pi OS installation... I think ondemand governor is set using a udev rule. The file...
View ArticleTroubleshooting • Re: Rpi 400 won’t boot
Hi I have been using my raspberry pi 400 for a few years now, but I recently forgot the password.So, what did you do with this SD card?Statistics: Posted by ame — Tue Jan 21, 2025 2:44 am
View ArticleRaspberry Pi 400 and 500 • Re: Pi 500 build problems
I don't find the flexing any different to my Pi400. It all sits square on my desk and when out and about. Perhaps you just have a bad one. Ask for it to be replaced.I also didn't experience any more...
View ArticleNetworking and servers • Raspberry Pi NAS setup with USB HDD
Guys,I realize that very similar posts have happened in the past but as you guys are aware, unless things fall specifically into what someoneis doing, sometimes newbies like myself need more guidance....
View ArticleAdvanced users • Re: Raspberry pi 5 won't boot automatically some times when...
I have 3 pi5 running last raspberry pi image, some times when electrical power outage, i need press power button for boot.I'm using official power supply for raspberry pi 5.somebody got same issue?I...
View ArticleTroubleshooting • Re: ffmpeg connection refused issue
I didn't setup a listener. I didn't realize I needed to. Any suggestions for something simple?Statistics: Posted by fabnavigator — Tue Jan 21, 2025 3:39 am
View ArticleAutomation, sensing and robotics • How to Control SMC PVQ13 Proportional...
Hello,I’m working on a project where I need to control an SMC PVQ13 proportional valve using a Raspberry Pi.So far, I’ve attempted to use an IRF540N MOSFET module to drive the valve by varying the PWM...
View ArticleCamera board • Re: does an "affordable" C/CS-mount macro lens exist?
Good results from that setup, and also very nice presentation of the front-and-back macro photos of the R-Pi board! It's a really neat sort of viewing setup, which I have never seen before.Statistics:...
View ArticleClik here to view.
Compute Module • Re: debug uart for CM5 on CM5 IO devkit
thank you, 'have done that. Is there anything special to configure the JST connector on cm5 or is it enabled by default?measured 3,3V on the orange cable but for now can`t get console output(soldering...
View ArticleGeneral • Re: Pico Cannot Handle Multiple Servos ?
I have the Mk.1 board. You cannot see the reverse of the board in the above photos. A trace runs from Pico Vsys to the jumper Vsys. This is a straight link; no components. This should not be used in...
View ArticleOther • Re: How to force console output res at 480x320 on RPI5
It has a native resolution of 480x320!!And.. again.. I was able to set it at its native resolution with previous RPI3A+.. but it seems impossible with RPI5 It is a Kedei 3.5inch HDMI...
View ArticleGeneral discussion • Re: can a 5v at 4.5A will be enough
https://www.stuffcool.com/products/mega ... -powerbankStatistics: Posted by DI-HAL — Tue Jan 21, 2025 5:28 am
View ArticleAutomation, sensing and robotics • Re: (Yet another) Water cooler volume...
I got this running and it is working fine. It sends the weight (in pounds) to my Android phone every 30 minutes using Tasker and AutoRemote. Tasker converts the pounds to a percent full value and...
View ArticleTroubleshooting • HDMI connection failed
HDMI connection failed in xenomai Linux raspberrypi 5.10.191-xenomai #1 SMP PREEMPT IRQPIPE Tue Jan 21 03:48:01 CST 2025 aarch64 GNU/Linux.It was originally working with Linux raspberrypi...
View ArticleRaspberry Pi OS • HDMI Audio with Desktop but not Console boot (Bookworm)
Can anyone explain to me why I can get HDMI audio when booting to desktop but not when booting to console? Based on other posts I was able to get audio via HDMI in console boot by updating...
View ArticleDevice Tree • Re: RPi5 dtoverlay i2c-fan fails with i2c-path parameter
Yes, it should work fine with i2c2 on Pi 5 provided the pins are suitable for your application:Code: Usage: dtoverlay=i2c2-pi5,<param>=<val>Good evening, I believe my configuration...
View Article